Specific Heat Capacity Module (Add‑on) - Measurement modules - Hot Disk

Illustration for the Hot Disk Specific Heat Capacity Module

Direct Cp testing of complex samples

This dedicated module excels in determining the specific heat capacity of solid or liquid samples.

Like all other Hot Disk testing, the procedure is gentle and non-destructive. The sample to be tested is placed in an insulated gold container and carefully heated a few degrees with a well-defined heating effect, allowing very accurate calculation of specific heat.

The Specific Heat Capacity Measurement Module is designed for single sample testing.

Specific Heat Capacity Range:

Instruments	Range
TPS 3500, TPS 2500 S, TPS 2200, TPS 1500, TPS 1000, TPS 500 S	up to 5 MJ/m³K

Works with the following Hot Disk® instruments

Updated

TPS 3500

TPS 2500 S

TPS 2200

TPS 1500

Hot Disk® TPS 1000 front view

New

TPS 1000

TPS 500 S

Other Measurement Modules

Illustration for the Hot Disk Isotropic Standard Module

Isotropic Module (Standard)

All-round testing of bulk thermal conductivity

Illustration for the Hot Disk Anisotropic Module

Updated

Anisotropic Module (Add‑on)

Testing direction dependent Thermal Conductivity, Thermal Diffusivity and Thermal Effusivity on samples with 2D or 3D anisotropy.

Illustration for the Hot Disk Slab Module

Slab Module (Add‑on)

Two-dimensional testing of sheet or slab samples

Illustration for the Hot Disk One-Dimensional Module

One-Dimensional Module (Add‑on)

Testing thermal properties of rod-like samples

Illustration for the Hot Disk Thin Film Module

Thin Film Module (Add‑on)

Testing through-film thermal conductivity

Illustration for the Hot Disk Low-Density / Highly-Insulating Module

Low-Density / Highly-Insulating Module (Add‑on)

For measurements of the lightest and most insulating samples

Illustration for the Hot Disk Structural Probe Module

Structural Probe Module (Add‑on)

Identify trends and defects inside the sample

Illustration for the Hot Disk Single-Sided Testing Module

Single-Sided Testing Module (Add‑on)

For rapid testing of limited sample volumes

Illustration for the Hot Disk Automatization Module

Automatisation Module (Add‑on)

Remote-control the equipment using TCP/IP

Quotation Inquiries

Support Inquiries