Low-Density / Highly-Insulating Module (Add‑on) - Measurement modules - Hot Disk

Illustration for the Hot Disk Low-Density / Highly-Insulating Module

For measurements of the lightest and most insulating samples

To improve accuracy when analysing very low-conducting materials such as aerogels, this module is an essential addition. These materials displays such a low thermal conductivity that heat loss through the sensor medium – in this case cables – becomes significant.

Utilizing this module the heat loss can be accurately corrected for, making it possible to measure extremely low thermal conductivities.

The Low-Density / Highly-Insulating Measurement Module requires two sample halves for testing.

Thermal Conductivity Range:

Instruments	Range
TPS 3500, TPS 2500 S, TPS 2200, TPS 1500, TPS 1000	0.01 to 0.5 W/m/K

Works with the following Hot Disk® instruments

Updated

TPS 3500

TPS 2500 S

TPS 2200

TPS 1500

Hot Disk® TPS 1000 front view

New

TPS 1000

Other Measurement Modules

Illustration for the Hot Disk Isotropic Standard Module

Isotropic Module (Standard)

All-round testing of bulk thermal conductivity

Illustration for the Hot Disk Anisotropic Module

Updated

Anisotropic Module (Add‑on)

Testing direction dependent Thermal Conductivity, Thermal Diffusivity and Thermal Effusivity on samples with 2D or 3D anisotropy.

Illustration for the Hot Disk Slab Module

Slab Module (Add‑on)

Two-dimensional testing of sheet or slab samples

Illustration for the Hot Disk One-Dimensional Module

One-Dimensional Module (Add‑on)

Testing thermal properties of rod-like samples

Illustration for the Hot Disk Thin Film Module

Thin Film Module (Add‑on)

Testing through-film thermal conductivity

Illustration for the Hot Disk Specific Heat Capacity Module

Specific Heat Capacity Module (Add‑on)

Direct Cp testing of complex samples

Illustration for the Hot Disk Structural Probe Module

Structural Probe Module (Add‑on)

Identify trends and defects inside the sample

Illustration for the Hot Disk Single-Sided Testing Module

Single-Sided Testing Module (Add‑on)

For rapid testing of limited sample volumes

Illustration for the Hot Disk Automatization Module

Automatisation Module (Add‑on)

Remote-control the equipment using TCP/IP

Quotation Inquiries

Support Inquiries